6
7
1.
Ensure the plastic clips of the mounting frame are facing into
the hole as shown.
2.
Feed the full system through the forearm, and pull the
Display through so it exits the forearm through the mounting
frame hole. If required, fold the ribbon cable at 90° at a
distance of 5mm minimum from the Display to allow it to run
along the forearm and use the extension cable if extra length
is required.
3.
Sit the Display flat on top of the mounting frame and push
it into the frame until it clicks into place. The front of the
display should sit flush with the mounting frame and the
whole unit should feel secure in the forearm. Use green
dispenser tip to apply silicone sealant to the gap between
the Display unit and the mounting frame ensuring it is water
tight.
4. Secure the system inside the forearm using hook and loop
fasteners or similar to prevent movement.
Fitting of new S-Charge Hub
The Steeper S-Charge System and its associated components are not waterproof and should not be exposed
to moisture. Ingress of moisture may cause corrosion and potentially severe damage.
These products are not designed to be opened and have no user accessible or replaceable internal
components.
In the event of failure or suspected malfunction, please contact Steeper or your supplier.
If the S-Charge System or components have either been in storage or have been transported for longer than 1
hour, please leave in an ambient temperature (20° C) for a minimum of 2 hours before use.
For further information or troubleshooting guidance, please refer to the S-Charge System Technical Manual
on the Steeper website.
Warning
: do not modify this equipment.
S-Charge System:
Important Information
