Rail Runner
Rail Runner Operator’s Manual
14
Set
the pressing
lever to ON (
5
) to press the front rollers to the track. Slide the carriage
to the required position
(
6
), and
fully
tighten
the
drive
clutch
knob
(
7
)
to
engage
the
gear
of
the
carriage with the rack of the rail. Then, loosen the knob by
1/4 rotation.
At heights, protect the carriage and the track from falling. To do this, fasten the
track to a fixed structure with chains attached to the leftmost and rightmost magnetic
units. Protect the carriage by attaching a chain to a carrying handle. The chains (not
included) must not be loose.
Plug the power cord
into
the power source, and
then insert
the torch into the torch
holder and
secure
with the
knob.
Next, insert the torch cable into the cable anchor,
secure with knobs, and then fix the anchor in the required position with levers.
3.4. Connecting to the welding circuits
The carriage can control two torches by using the arc ignition cable plugged into
the arc ignition socket. To do this, according to the diagram shown in Fig. 5 connect
any blue-jacketed wire to any terminal of the welding circuit. Then, connect the
second blue-jacketed wire to the second terminal of the same circuit. To control
the second torch, connect the green-jacketed wires to the terminals of the second
welding circuit.
Fig. 5.
Connecting the arc ignition cable to welding circuits
To make sure that the
arc
ignition
cable
is
connected
correctly, turn on the power of
the carriage, and then set
the arc ignition
switch
to the position TEST. This should
enable the arc for a while.
blue
blue
Welding circuit 1
g
re
e
n
g
re
e
n
Welding circuit 2
