Rail Runner Gen III
Rail Runner Gen III Operator’s Manual
22
Parameter Value
Description
Method of
control
Behavior when the limit switch is activated.
Rotate
Stops the carriage and arc. To continue, set the
direction switch to ‘O’. This travels the carriage
back by 10 mm (0.5 in) and removes
the information symbol.
Stops the arc and travels the carriage back to the
initial position from where the move started.
To continue after the carriage reaches the initial
position, set the direction switch to ‘O’. This re-
moves the information symbol.
Stops the carriage and arc. To continue, do 1 or 2.
1) Press F1, F2, or F3 to travel the carriage back
to the initial position from where the move
started.
2)
Set the direction switch to ‘O’ to travel the
carriage back by 10 mm (0.5 in).
Stitch welding.
Rotate
Off. The carriage welds continuously.
On. Activates parameters of stitch welding. Do not
set them to zero if you want to weld continuously.
Instead, set stitch welding to OFF.
0
–100 cm
0
–40 in
[step: 0.1]
Weld length (parameter available only when the
stitch welding is set to ON).
Rotate
OR
0
–100 cm
0
–40 in
[step: 0.1]
Space before welding.
Press, hold,
and rotate
0
–100 cm
0
–40 in
[step: 0.1]
Space between welds (only for stitch welding).
Rotate
100
–999 cm
40
–400 in
∞
[step: 1/0.5]
Total length. After reaching the total length the
carriage acts as if the limit switch is activated.
Rotate or
press
0
–10 cm
0
–4 in
[step: 0.1]
Backweld length (parameter available only when
the stitch welding is set to ON).
Rotate
OR
0
–30 s
[step: 0.1]
Crater fill time before welding.
Press, hold,
and rotate