-22-
ST1013 12" Jointer (Mfd. Since 3/16)
OPERATIONS
The Model ST1013 will perform many types of opera-
tions that are beyond the scope of this manual. Many
of these operations can be dangerous or deadly if
performed incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at
any time you are experiencing difficulties performing
any operation, stop using the machine!
If you are an inexperienced operator, we strongly
recommend that you read books, trade articles, or
seek training from an experienced jointer operator
before performing any unfamiliar operations. Above
all, your safety should come first!
Overview
To complete a typical operation, the operator
does the following:
1. Examines workpiece to verify it is safe and suit-
able for cutting.
2. Adjusts fence for width of workpiece and locks it
in place.
3. Adjusts fence tilt, if necessary.
4. Adjusts infeed table height to set depth-of-cut
per pass.
5. Puts on safety glasses, respirator, and ear
protection.
6. Locates push blocks.
7. Starts jointer.
8. Holds workpiece firmly against infeed table
and fence, and slides it into cutterhead at a
steady and controlled rate until entire length of
workpiece has advanced beyond cutterhead to
outfeed table.
9. Repeats cutting process until desired results are
achieved.
10. Stops jointer.
Loose hair/clothing could
get caught in machinery
and cause serious person-
al injury. Keep clothing and
long hair away from moving
machinery.
Eye injuries or respiratory problems can occur
while operating this tool. Wear personal pro-
tective equipment to reduce your risk from
these hazards.
DO NOT investigate prob-
lems or adjust the lathe
while it is running. Wait
until the machine is turned
OFF, unplugged and all
working parts have come
to a complete stop before
proceeding!
If you have never used this type of machine
or equipment before, WE STRONGLY RECOM-
MEND that you read books, trade magazines,
or get formal training before beginning any
projects.
