STEELE PRODUCTS PARADISE GS-32, Instructional Book, Care & Use/Installation

Page: 9 / 35

Connection
Slide the grill forward to gain access to the regulator and gas connection point in the rear. Connect a
suitable natural gas flex connector to the grill regulator.
Check the grill controls to ensure all control valves are in the full OFF position.
Turn on the main gas supply and check all connections for leaks using soapy water as Described in the
leak testing procedure section.
Warning: If you see bubbles in the soapy solution at any of the connections, turn off the gas supply and
tighten the connection. If tightening the connection does not seal the leak, it may be necessary to replace
the flex hose.
Checking for Gas Leaks
Perform a leak test at least once a year whether the gas supply cylinder has been
disconnected or not. In addition, whenever the gas cylinder is connected to the regulator or
whenever any part of the gas system is disconnected or replaced, perform a leak test.
As a safety precaution, remember to always leak test your grill outdoors in a well-ventilated
area. Never smoke or permit sources of ignition in the area while doing a leak test. Do not use
a flame, such as a lighted match to test for leaks. Use a solution of soapy water.
Prepare a leak testing solution of soapy water by mixing in a spray bottle one part liquid soap
to one part water.
Make sure all the control knobs are in the OFF
position. Turn on the gas
• On N atural Gas systems , turn the main feed valve to the grill.
•
On LP systems , turn the cylinder valve knob counter clockwise one turn to open.
Paradise Grilling Systems Instructional Book
9