HEAVY DUTY BULL NOSE FRONT BUMPER
2015-17 CHEVY SILVERADO 25-3500
Page 5 of 6
3/30/17 (DP)
IMPORTANT
: Sensors fit snug in sockets. The
4mm Screws are only used to apply slight
pressure to lock the sensors in place. Tighten
both screws evenly until they touch the sensor
body only. Do not overtighten screws or damage
to sensors will result.
Driver side installation pictured
WARNING!
Do not crawl under bumper
unless the bumper is properly supported on
blocks or stands or the bumper may fall.
(3) 12mm x 55mm Hex Bolts
(6) 12mm Flat Washers
(3) 12mm Nylon Lock Nuts
(3) 12mm x 55mm Hex Bolts
(6) 12mm Flat Washers
(3) 12mm Nylon Lock Nuts
(Fig 11) Winch Tray and Brackets
(Fig 10) Attach Winch Tray to inside of Brackets
Front
Front
(Fig 13) Attach Bumper to Brackets
Front
(Fig 12) Push sensor into mounting
sleeve. Use 4mm Screws to lock sensor
in place.
