Operation and settings
Migration Manual -en- 2019
Page 22 of 35
Manuel reset via Up/Down control panel
An end position calibration of the lowest desktop position must be performed:
•
Before first use.
•
When the actual desktop position no longer matches the displayed desktop position.
•
When a previously configured motor controller is used in a different electrically height adjustable workstation
of the same design.
WARNING
Danger of crushing and shearing!
The software-supported stopping device is not active during the reset
movement and for the end position calibration.
Keep a sufficient distance from the desk during the reset movement.
Press and hold the "Down" button until the lower end position (programmed
desktop position) is reached.
Release the "Down" button.
Again, press and hold the "Down" button for approx. 5 s.
The desktop moves to the lower end position.
Release the "Down" button. The system is now ready for operation.
If the button is released before the process is completely concluded, the manual reset process will be
interrupted and must be restarted.
