Active Touch Controller
RESETTING THE ACTIVE TOUCH DISPLAY HEIGHT
•
Press
1
,
2
,
1
,
2
. The text will begin blinking “SELECT”, “HEIGHT”.
•
Lift
up
or press
down
on the controller to scroll through the starting height options.
•
Once the correct height has been chosen, pause for 2 seconds.
•
The light guide will fill. When all three bars are full, the starting height is saved.
ADJUSTING THE HEIGHT DISPLAYED
•
It may be necessary to adjust the height displayed, which is set to the default
setting from the factory.
•
Press and hold the
1
,
2
and buttons simultaneously for four seconds.
•
The display will flash “ADJUST HEIGHT”, and then the current desk height
will flash on the display.
•
Lift
up
or press
down
on the controller to change the height displayed.
The new desk height will flash until the light guide fills.
TIP:
The desk should
not move during this step.
SWITCH DISPLAY FROM INCHES TO CENTIMETERS
•
Press and hold the
1
and buttons simultaneously for three seconds, to
change the display from “INCH” to “CM”. The new selection will flash until the
light guide fills.
ERROR CODES
•
In the event of a fault, the display may show an error code number and brief
description. Refer to the Steelcase Flex Collection Height-Adjustable Desk
troubleshooting guide for further instruction.
