®
2
Installing Driveshafts
LONG
PARTS
SHORT
PARTS
On 3-leg tables, be sure to use the correct
length of driveshaft for the particular side of
the worksurface. Use longer components on the
long side, and shorter components on the short
side, where applicable.
If the hexagon openings are not perfectly aligned, grip
1
the driveshaft with an adjustable wrench and rotate
NOTE: DO NOT pound the driveshafts through with a
hammer. This will mushroom the end of the driveshaft.
slightly, until the driveshaft slides through with ease.
FOR LONG SIDE
FOR SHORT SIDE
1
2
Place cap nut on a flat, hard surface and push
driveshaft into it.
Feed driveshaft through leg, from outside,
until cap nut bottoms out on leg.
3
3
Right-Hand Table
Shown This View)
(Equal-Sized or
Note: Set screw must be loosened slightly
to allow insertion of shaft. Set screw to be
tightened very tightly after all shafts are in
final position. See step #8.
CAP NUT
SET SCREW
Page 17 of 35
004231D Rev T
