BM-18
This document is protected by copyrights.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions Ltd is prohibited.
13
3.6. Replacing the cutting inserts
Unplug the power cord. Loosen the screw (
1
) and turn the sleeve (
2
) to lower it as far
as possible and get access to the milling head. Use the T15 torx screwdriver to
remove the cutting inserts (
3
,
4
). Clean the sockets.
To change the cutting edge, remove the inserts and turn them by 90° or 180°.
Then, push them to the sockets and tighten. If all the cutting edges are worn, install
new inserts. Make sure that the bottom of each insert is in full contact with the
socket (
5
).
Each week clean the threads of the mounting screws for inserts and put the
supplied grease on the threads.
1
2
4
INCORRECT
×
CORRECT
✓
3
5
