Page 14
◊ FEED SPEED
The conveyor belt has variable speed , controlled by the
speed selector dial (
O
) of the worm gear reducer
mounted on the conveyor, in the back of the sander.
Turn the dial clockwise to decrease the speed,
counter-clockwise to increase it.
IMPORTANT:
CHANGE THE FEED SPEED ONLY WHILE
THE MACHINE IS RUNNING.
FAILURE TO DO SO MAY CAUSE GEARBOX
DAMAGE.
◊ CONVEYOR BELT
The belt should always run at the center of the contact
drum. The belt tracking and tension are adjusted at the
factory.
However, should they require correction the adjustment
bolts are located on each side of the conveyor front
roller. Disconnect the machine from power. Turn the
bolts to increase/decrease the tension or correct the belt
tracking.
◊ V-BELT TENSION
After the machine has been in operation for some time,
the V-belts might need to be re-adjusted.
Disconnect the machine from power. Remove the lower
right access door. Check the belt tension; each belt
should deflect by about 3/4”-1’’ when pushed moderately
at mid distance between the motor pulley and the roller
pulley.
If correction is required, raise or lower the motor base-
plate by mean of the tensioning bolt (
P
) and/or correct
the tension on the intermediate bender (
Q
).
NOTE: Keep V-belts correctly tensioned to
ensure proper functionality of emergency stop
brake (R). The emergency disc brake must be
able to stop the sanding drum.
O
Q
P
R
Summary of Contents for TITANIUM 50-510
