Page 17
MAINTENANCE
◊ LUBRICATION AND MAINTENANCE
1. The machine interior should be thoroughly cleaned
every day after work. Remove the sanding belts before
cleaning and replace them afterwards.
2. The bearings should be greased after every 100 hrs of
use.
3. The water should be drained from the filter cups
regularly.
4. Monthly, apply a good amount of grease on the table
elevation screws, and apply grease to the chain and
gears mechanism.
Pay attention not to put grease on
the V-belts.
5. The oil in the gear reducer should be changed after the
first 300 hours, and every 2500 hours of use thereafter.
6. Test the safety features on a regular basis.
7. Check for damaged or worn sanding belts. Replace if
required.
Summary of Contents for TITANIUM 50-510
