Steel City 50125, User Manual

Page: 18 / 34

2. Once the belt is installed, confirm that the pulleys
are aligned using a straight edge on the outer face
of both pulleys. If an adjustment is necessary, loosen
pulley and set the motor itself can be repositioned by
loosening the four bolts that attach the motor to the
motor plate, repositioning the motor, and then
retightening the four bolts. SEE FIG. 7.
Fig.7
3. Install one M10 Hex Nut (D) onto the motor
tensioning bolt (E) and thread the bolt into the base
of the bandsaw.
4. Tighten the motor tensioning bolt until it can comes
in contact with the motor plate. Continue tightening
until there is about 1” deflection in the belt when
squeezed at its midpoint. Once the correct belt
tension is achieved, tighten hex nut from step 3
until it bottoms out against the base.
SEE FIG. 8.
Fig.8
D
E
5. Fasten the pulley cover (E) to the bandsaw using the
three pan head flange screws.
6. Install the thin cabinet plate that can't be installed in
page 17 step 4.
SEE FIG. 9.
Fig.9
1
8
E