17
ADJUSTMENTS
LEVELING EXTENSION TABLES
The extension tables must be level with the planer
table. To check the extension tables and adjust if
necessary:
1.
Lay a straight edge (A) on the planer table (C) with
one end of the straight edge over the infeed table
(B).
SEE FIG 4.
Fig. 4
B
A
2.
Check to make sure that the infeed table is level
with the planer table.
3.
If an adjustment is necessary, loosen and adjust
Pan Head Screws (3) (D) on each side of the
table until the infeed table is level with the planer
table. This will adjust the outer edge of the infeed
table.
4.
Repeat this process for adjusting the outfeed table.
RAISING AND LOWERING
HEAD ASSEMBLY
The head assembly consists of the cutterhead and
knives, feed rollers, cutterhead guard, and the motor.
Raising and lowering of the head assembly controls
the depth of cut on the planer. To adjust:
1.
To raise the head assembly (A), turn the adjusting
handle (B) clockwise.
SEE FIG 5.
Fig. 5
2.
To lower the head assembly, turn the adjusting
handle counterclockwise.
NOTE:
One revolution of the handle will move the
cutterhead up or down approximately 1/16”. You can
confirm this by referencing the scale (C) on the right
side of the planer.
A
B
C
C
D
All manuals and user guides at all-guides.com
Summary of Contents for 40300H
