Steel City 35635, User Manual

Page: 14 / 40

14
ELECTRICAL REQUIREMENTS
TO PREVENT
electrical shock, follow all electrical and
safety codes, including the National Electrical Code
(NEC) and the Occupational Safety and Health
Regulations (OSHA). All electrical connections and
wiring should be made by qualified personnel only.
TO REDUCE
the risk of electrical shock,
DO NOT
use
machine outdoors.
DO NOT
expose to rain or mois-
ture. Store indoors in a dry area.
DO NOT
connect the machine to the power source
before you have completed the set up process.
DO NOT
connect the machine to the power source until
instructed to do so.
This motor in this machine is designed to run at 230V.
Power connections must be made at the switch.
For connections, refer to wiring photo Fig. A.
On your incoming power line:
1. The White Lead connects to terminal L1.
2. The Black Lead connects to terminal L3.
3. The Ground Wire connects to the grounding
terminal.
Notice:
Some Table Saws will be equipped with a junc-
tion box located near the base of the saw. If this is the
case with your model saw, all power connections will be
made in the junction box instead of at the switch. The
junction box will have markings for L1, L3, and Ground.
Following the steps above, connect the wires to their
proper terminals.
WHITE LEAD TO
L1 TERMINAL
BLACK LEAD TO
L3 TERMINAL
GROUND WIRE
TO GROUNDING
TERMINAL
USE THIS SETUP FOR MODEL NUMBER 35636 ONLY
Fig. A