Steel City 35600, User Manual

Page: 19 / 44

19
Fig. 7
1. Assemble both of the fence hooks (A) to the left
side of the cabinet (B) using four 1/4-20 x 1/2”
round head screws, not shown.
SEE FIG. 7.
2. Assemble the wrench hook (C) above the fence
hooks using two sheet metal screws, not shown.
WRENCH AND FENCE
HOOK ASSEMBLY
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
B
C
A
BLADE GUARD AND
SPLITTER ASSEMBLY
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
Fig. 8
2. Place the threaded end of the mounting splitter rod
(A) through the hole (B) in the rear of the cabinet.
Place a M12 hex nut (not shown) onto the threaded
end of the mounting splitter rod inside of the cabi-
net and tighten securely.
SEE FIGS. 8 AND 9.
Note: Place an 18mm wrench on 12mm hex nut and a
13mm wrench on flats of the splitter rod and tighten.
Fig. 9
3. Place the splitter bracket assembly (C) onto the
mounting splitter rod.
SEE FIG. 9.
B
Fig. 10
1. Remove the table insert. Note: Remove the table
insert retaining bolt used to secure the table insert
to the saw table.
4. Place the front attachment point (D) of the blade
guard and splitter assembly down into the tool-less
front attachment point (E). Place the rear attachment
slot (F) onto the threads of the splitter bracket knob
(G); securely tighten splitter bracket knob. Note: The
splitter bracket assembly will need to be positioned
to fit the blade guard and splitter assembly on the
mounting splitter rod.
SEE FIG. 10.
A
C
E
D
G
F
WARNING
!
WARNING
!