Page 18
ANTI-KICK BACK FINGERS
They are provided on your planer to prevent kickback.
These fingers operate by gravity and its necessary to
inspect them occasionally to make sure they are free of
gum and pitch so that they move independently and
operate correctly.
RELATION
BETWEEN
FEEDING
ROLLERS, CHIPBREAKER, PRESSURE
BAR AND CUTTING CIRCLE
The infeed roller, chipbreaker, pressure bar and outfeed
roller are adjusted at the factory. The infeed roller and the
chipbreaker to be set .004” (0,1 mm) below the cutting
circle, the pressure bar to be set .008” (0,2 mm) below the
cutting circle, as shown on the draw. If an adjustment to
the infeed roller, chipbreaker, pressure bar or outfeed
roller is necessary, contact a qualified technician.
1. To control the relation between cutterhead and out-
feed roller, place the gage block on the table directly
underneath the cutterhead. Using a .02” (0,5 mm) feeler
gage placed on top of the gage block, raise the working
table until the knife just touches the feeler gage when the
knife is at its lowest point. Do not move the working table
any further until the ooufeed roller is adjusted.
2. Move the gage block under the end of the outfeed
roller. The bottom of the outfeed roller should just touch
the top of the gage block.
3. Check and adjust opposite end of the outfeed roller
in the same manner.
NOTE: Be sure the knives are adjusted prop-
erly as previously explained.
WARNING
!
Make certain that machine are disconnected
from the power source.
Be careful, knifes are very sharps. Wear
gloves!!
FEED SPEED CONTROL
Your machine is equipped with a spiral, serrated infeed
roller and a solid steel outfeed roller. When the feed rollers
are engaged, they turn to feed the stock. The feed rollers
slow automatically when the machine is under heavy load
for best planing under all conditions. The feed rollers are
driven by chains and sprockets, which takes power
directly from the cutterhead through the oil bath gear box.
There are two feed speeds in the gear box by using the
shift lever to pull out or push in, and the feed speed range.
Speed rate of feed roll is transmitted by shaft geards in
gear box.
There are 3 kinds of operations of gearbox by using shaft
handle to pull or push.
Anti-kick back fingers
Outfeed roller
Pressure bar
Cutterhead
Infeed rolle
Chip breaker
Summary of Contents for 35-410
