Protective Covering
“Remove Before
Installation”
Modular Jack
Plug
Knockout for
Strain Relief
To Control
¾" Conduit
Coupler
Gasket
Control Cable
to Generator
Installation and Operating Instructions
IMPORTANT: Test Control for operation before installing
face plate.
6. To install Face Plate, peel back the (2) paper liners on
Base Plate to expose adhesive surfaces. Attach Face
Plate to the control.
7. Clean the face and Base Plate Assembly with a damp
cloth after installation to remove all dust, dirt, grime, etc.
Figure 1
Model: DSC-425
Figure 2 - Back of Control
02/09
Pub. No. 120-F
- 2 -
3. Carefully route the other end of the multi-conductor control
cable from the Steambath Generator to the DSC-425 inside
the steamroom. Route multi-conductor cable through a ¾"
conduit to protect the cable from damage and to facilitate
replacement if necessary.
4.
Using the knockout either on top or bottom of the switch box,
secure cable with a strain relief fitting (provided). It is
suggested that the strain relief fitting be installed from inside
the switch box so cable may be adjusted. Allow approximately
10" - 12" of cable to extend into the box beyond the strain relief
fitting. Protect control cable by placing it inside the switch box
during construction, with the protective cap installed over the
end (see Figure 3).
5.
After the walls are finished you are now ready to wire and
install the DSC-425 Control Digital On/Off Elapsed
Time/Temp.
CAUTION:
Electrical Power to the Steambath Generator must be
OFF before making connections.
a) Locate Telco Jack at female coupler, on back of control.
Remove the protective covering labeled “Remove Before
Installation.” Remove protective cap from cable and plug
into jack. Check that the orientation of the plug properly
aligns with the jack. A snap will indicate the plug is installed
correctly (see Figure 2).
b) Mount Base Plate Assembly to the switch box using No.
6-32 x 2" S/S SCREWS (supplied in the plastic mounting
hardware bag).
IMPORTANT: DSC-425 Control MUST be mounted inside
the steamroom. Silicone sealant (supplied) MUST be used
to form a watertight seal to the wall.
