20
Maintenance
16.0
Care And Maintenance 16.1
Ensure the hardware you are using stays in working order by keeping it cared
for and maintained.
Keep electronics dry and out of the water.
Periodically check the hardware for looses screws or worn parts. Replace or repair the parts
as needed.
To clean the aluminum, use a mild, nonabrasive household cleaner.
On the hardware, lightly tighten set screws until they are snug, then tighten an extra
quarter turn.
Ensure strain relief is tight (slightly pull on power cord and ensure strain relief is tight).
Safety 16.2
Avoid getting electronics wet and working on electronics with wet or damp
hands. This could cause minor to severe electrocution, resulting in personal
injury and/or product damage.
Technical Data
16.3
The i-Drive Bluetooth Interface was tested and found to be in compliance with
the required criteria and met the standards of IEC60601-1-2:2014 (Edition 4.0);
RESNA WC-2:2009.
WARNING
Do no overtighten set screws. Over tightening set screws will prevent hardware
from functioning properly and could cause irreversible damage to the
hardware.
CAUTION
Periodically check Diagnostics for real-time data information to verify that all
sensors are functioning properly.
Summary of Contents for i-Drive 4.0
Page 30: ...a Notes 17 0...
Page 31: ...b Notes 17 0...
