18
Testing
14.0
After the installation of the i-Drive, execute the following tests before the
wheelchair is delivered or put into service:
Operational Test
Test Drive
Stop Test
Operational Test 14.1
1.
Activate the wheelchair operating system.
2.
Check for any error messages.
3.
Apply pressure to the head pad/sensor/joystick, etc. designated for moving the chair in a
forward motion until you hear the parking breaks switch off. The wheelchair may start
moving.
4.
Immediately release the pressure from the head pad/sensor/joystick, etc. You should hear
the parking break react within a few seconds.
5.
Repeat
Steps 3 & 4
three times, while carefully applying pressure to the device.
6.
Check whether the double tap features function properly.
Test Drive 14.2
Perform a test drive with the wheelchair.
Check whether the wheelchair and all of its operations are fully functioning.
Check that no cabling or parts may get damaged or hindered in any possible position
of the wheelchair.
WARNING
Execute this test only on a level surface, in an open area free of obstacles.
Summary of Contents for i-Drive 4.0
Page 30: ...a Notes 17 0...
Page 31: ...b Notes 17 0...
