Stealth Cam STC-G42NG, Instruction Manual

Page: 15 / 60

www.stealthcam.com Page
877-­‐269-­‐8490
15
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
§ PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the
time that the camera will wait before it reinitializes its PIR sensor for the next
activation. With the TL mode this setting is only active if TL Delay is set to 1 min or
greater. This setting can be changed between the numbers of 00min 05sec to 59min
59sec. With this option blinking, use of the UP and DOWN arrows will allow the
minutes setting to be changed from 00 to 59. Once this setting is on the appropriate
minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed
from 05 to 59
(05 to 59 if minutes = 00).
•
TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME
LAPSE images. This setting can be changed between the numbers of 00min 05sec to
59min 59sec. With this option blinking, use of the UP and DOWN arrows will allow the
minutes setting to be changed from 00 to 59. Once this setting is on the appropriate
minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed
from 00 to 59
(05 to 59 if minutes = 00). If the TL Delay is greater than or equal to 1
min, then the PIR sensor will be active between time-­‐lapse photos.
•
TL START – 06:00PM (default): This setting is used to give the camera the start time for
when to start the time-­‐lapse photography. The default format is in a HH/MM/AP
setup, should the time format be in 24 hour the format it
will show HH/MM. With the HH (hour) setting blinking, use the UP and DOWN arrows
to allow the setting to be changed from 1 to 12. Once this setting is on
the
appropriate hour, press the RIGHT arrow key to move to the MM (minute) setting
and it will start to blink.