Stealth Cam STC-G42NG, Instruction Manual

Page: 13 / 60

www.stealthcam.com Page
877-­‐269-­‐8490
13
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
§ REDUCE BLUR – ON : This setting is used to determine if the camera should use
the MATRIX Blur reduction technology to dramatically reduce the blur effect
resulting in clearer night time infrared shots. With this option blinking, pressing
the UP or DOWN arrow buttons will cause the camera to cycle between the two
options of ON or OFF.
§ PHOTO BURST – 1 PHOTO (default): This setting is used to determine the number
of photos the camera will take during its activation. This setting can be changed
between 1 PHOTO up to 9 PHOTOS. With this option blinking, use the UP or
DOWN arrow key to move between the value range in increments of 1.
o
PIR VIDEO : In this mode the camera will take a video clip at a designated resolution for
a designated length with a designated time out when the camera senses activity in
front of the unit. This mode is available for both day and night activities.
§
PIR DELAY – 00min 05sec (default): This setting is used to determine the length
of the time that the camera will wait before it reinitializes its PIR sensor for the
next activation. With the TL mode this setting is only active if TL Delay is set to
1 min or greater. This setting can be changed between the numbers of 00min
05sec to 59min 59sec. With this option blinking, use of the UP and DOWN
arrows will allow the minutes setting to be changed from 00 to 59. Once this
setting is on the appropriate minutes, press the RIGHT arrow key to move to the
seconds setting and it will start to blink. Use of the UP and Down arrows will
allow the seconds setting to be changed from 00 to 59 (05 to 59 if minutes =
00).