Stealth Cam STC-G42NG, Instruction Manual

Page: 12 / 60

www.stealthcam.com Page
877-­‐269-­‐8490
12
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Ø
TIME FORMAT – 12 HOUR (default): This setting is used to tell camera if the time
programmed and displayed on the Info Bar should be in the basic 12 hour (AM/PM) format
or the 24 hour (military) format. With this option blinking, pressing the UP or DOWN arrow
buttons will cause the camera to cycle between the two options. NOTE: Should the format
be changed to 24 hour, the previous SETUP TIME will now be adjusted as such and remove
the AM/PM part of the time.
Ø
MODE – This setting is used to tell the camera how it should take its images. The camera is
equipped with TRIAD Technology, allowing for 3 different options to be selected by the user.
With this option blinking, use the UP or DOWN arrow key to move between the options of:
PIR PHOTO , PIR VIDEO , or TL . Based upon the selection chosen the menus for the camera
will change.
o
PIR PHOTO (default): In this mode the camera will take a designated amount of picture with a
designated time out when the camera senses activity in front of the unit. This mode is available for
both day and night activities.
§
PHOTO RES – 5.0 MP (default): This setting is used to determine the Megapixel resolution of
each image taken by the camera. With this option blinking, use the UP or DOWN arrow key
to move between the options of: 10MP, 8MP, 4MP, 2MP or 0.5MP. The higher the
resolution of an image the more space the file will take on the SD memory card.
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time
that the camera will wait before it reinitializes its PIR sensor for the next activation. With the
TL mode this setting is only active if TL Delay is set to 1 min or greater. This setting can be
changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking,
use of the UP and DOWN arrows will allow the minutes setting to be changed from 00 to
59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move to
the seconds setting and it will start to blink. Use of the UP and Down arrows will allow the
seconds setting to be changed from 00 to 59 (05 to 59 if minutes = 00).