Stealth Cam stc-g26ng, Instruction Manual

Page: 12 / 59

www.stealthcam.com Page
877-­‐269-­‐8490
12
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Ø
TIME FORMAT – 12 HOUR (default): This setting is used to tell camera if the time programmed
and displayed on the Info Bar should be in the basic 12 hour (AM/PM) format or the 24 hour
(military) format. With this option blinking, pressing the UP or DOWN arrow buttons will cause
the camera to cycle between the two options. NOTE: Should the format be changed to 24
hour, the previous SETUP TIME will now be adjusted as such and remove the AM/PM part of
the time.
Ø MODE – This setting is used to tell the camera how it should take its images. The camera is
equipped with TRIAD Technology, allowing for 3 different options to be selected by the user.
With this option blinking, use the UP or DOWN arrow key to move between the options of:
PIR
PHOTO , PIR VIDEO , or TL . Based upon the selection chosen the menus for the camera will
change.
o
PIR PHOTO (default): In this mode the camera will take a designated amount of picture
with a designated time out when the camera senses activity in front of the unit. This
mode is available for both day and night activities.
§
PHOTO RES – 4.0 MP (default): This setting is used to determine the Megapixel
resolution of each image taken by the camera. With this option blinking, use the UP
or DOWN arrow key to move between the options of: 8.0 MP, 4.0 MP, 2.0 MP or .5
MP. The higher the resolution of an image the more space the file will take on the
SD memory card.
§ PIR DELAY – 00min 05sec (default): This setting is used to determine the length of
the time that the camera will wait before it reinitializes its PIR sensor for the next
activation. With the TL mode this setting is only active if TL Delay is set to 1 min or
greater. This setting can be changed between the numbers of 00min 05sec to
59min 59sec. With this option blinking, use of the UP and DOWN arrows will