www.stealthcam.com
877-‐269-‐8490
Page 14
BATTERY REMOVAL & INSTALLATION
To remove the batteries from the unit; open the
case by squeezing and holding the ejection latch
on the bottom of the case firmly to remove the
battery tray.
New, Alkaline or Lithium, ‘AA’ batteries must be inserted
with the orientation as shown on the tray. As with most
electronic devices the negative (
-‐
) orientation of the
batteries should be against the springs. Failure to insert the
batteries properly will cause damage to the unit.
To reinsert the battery tray; position the tray so the base of the tray matches with the opening at the
bottom of the camera. The tray is molded so that incorrect insertion of the battery tray is not
possible. With the orientation correct simply slide the battery tray into its final locked position.
Should the battery tray not willingly slide into it destination, remove the tray and examine the area of
possible debris that may be causing the issue.
NOTE:
Replacing the batteries within three (3) minutes will not reset the cameras current
configurations.
**WARNING**
Do not mix new and old batteries.
Do not mix alkaline, standard, or rechargeable batteries.
Remove batteries from the tray if the unit will not be in use for extended period of time.
