www.stealthcam.com
877-‐269-‐8490
Page 11
CAMERA PROGRAMMING (CONT) -‐ PROGRAMMING FOR MANUAL CONFIGURATION
§
PIR/TLM – PIR
(default): This setting is used to determine if the camera will be in PIR (Passive
Infrared) or TLM (Time Lapse Mode) for acquiring images.
o
PIR
: In this mode the camera will take a designated amount of picture with a designated
time out when the camera senses activity in front of the unit. This mode is available for
both day and night activities.
o
TLM
: In this mode the camera will take a defined amount of pictures with a defined time
out between the defined hours of operation even if there is no activity in front of the
camera. This mode is fixed with the following values:
Start = 7:00am, End = 6:59pm,
Resolution = Hi, Burst = 1P, Time out = 120s
•
OK
: This button is used to save the configuration settings, set the Time & Date on the camera,
and Format the memory card in the unit. Pressing this button for 2 seconds without pressing
any other setting buttons will allow you to get into the Time, Date & Format options of the
camera.
o
T (Time):
This setting is used to give the camera the correct time to use on the Info Bar of
the images. The default format is in a HH/MM setup. With the HH (hour) setting blinking,
use the UP and DOWN arrows to change from 1 to 24 (military format). Once this setting
is on the appropriate hour, press the OK button to move to the MM (minute) setting and it
will start to blink. Using the UP and DOWN arrows will allow the setting to be change from
00 to 59. Once this setting is on the appropriate minute, press the OK button to move to
the Date.
o
D (Date)
: This setting is used to give the camera the correct date to use on the Info Bar of
the images. The format is in a MM/DD/YY setup. With the MM (month) setting blinking,
use the UP and DOWN arrows to be change the setting from 1 to
