www.stealthcam.com
877-‐269-‐8490
Page 10
CAMERA PROGRAMMING (CONT) -‐ PROGRAMMING FOR MANUAL CONFIGURATION
To program the E series camera for manual configuration, first move the switch to the TEST position.
Once the display shows the current configuration and the word tESt, then programming each setting
can be done by hitting the appropriate button. Once a setting is configured pressing the OK button
will save the setting.
§
TIME OUT -‐ 30 sec
(default): This setting is used to determine the length of time, in seconds,
that the camera will wait before it reinitializes its PIR sensor for the next activation. Pressing
the button will increase the length from as low as 5 seconds to 55 minutes.
§
RES -‐ 1 star
(1.3MP – default): This setting is used to determine the megapixel resolution of
each image taken by the camera. Pressing the button will decrease the resolution to 2 stars (3
MP) and again to 1 star (1.3MP) before returning again to 3 Stars (8MP). The higher the
resolution of an image the more space the file will take on the SD memory card.
§
BURST -‐ 1P
(default): This setting is used to determine the number of photos the camera will
take during its activation. This setting can be changed between 1 PHOTO up to 9 PHOTOS.
Pressing the button will increase the count up to 9 before returning to 1.
§
VIDEO – 10S
(default): This setting is used to determine the length of time, in seconds, of the
video recording. This setting can be changed between the numbers of 05 to 300. Pressing the
button will increase the length up to 300 before returning to 5.
