stayer CPT3000E, Operating Instructions Manual, Page: 23 / 60

ENGLISH
23
23
not attempt to repair it on your own. Contact the service
or have the saw repaired by a professional.
TABLE SAFETY ICONS
Denotes risk of personal injury or damage to the tool.
Lea este manual
antes de utilizar
el aparato.
Always wear
protective gloves
In accordance
with essential
requirements of the
European directive(s)
Always wear safety
goggles.
“Class II - The machine is double insulated; Earthing
wire is therefore not necessary.
Instructions for use
Placement tool
Carefully remove the tool and all loose items from the
shipping container.
Retain all packing materials until after you have inspected
and satisfactorily operated the machine.
Before setting up, repair or maintenance of
the appliance you must always turn off the
operating switch and pull out the mains plug!
Assembly
- Before each use check the proper function of all
installation fixtures of the plunge saw and only use the
plunge saw if everything works properly.
- Attach the work piece in such way that it cannot move
or bend during work. Line the work piece respectively.
- Always hold the plunge saw with both hands at the
hand grips (3) and (4).
- Always guide the plunge saw forward. Never draw the
plunge saw back!
- Place the plunge saw with the front part of the base
plate (5) on the work piece. Guide the plunge saw only
against the work piece during operation.
- With the correct forward speed you prevent overheating
of the saw blade, and melting when cutting plastics.
Plunge saw feature
Selector switch
Use the selector switch (17) to set the respective operation
mode.
Corte de
inmersión
Corte de
marcado
Cambio de hoja
de sierra
Guide rails and clamps (Fig. 1)
Fixing with the clamps ensures solid grip and safe work.
- Place the guide rail on the work piece and fix the guide
rail with the clamps. Slide the bar into the groove of the
guide rail and tighten the clamp with the lever.
- Place the plunge saw on the guide rail. The base plate
has a groove (13), which exactly fits into the guide
ridge of the rail.
Descripción ilustrada
1. On/off switch
2. Lock-off button
3. Main handle
4. Auxiliary handle
5. Base
6. Anti-kickback knob
7. Adjustment knob for guide track
8. Bevel lock knob
9. Depth adjustment knob
10. Depth adjustment stopper
11. Depth scale
12. Blade
13. Slot for track
14. Cutting indicators
15. Cutting width indicators
16. Dust extraction outlet
17. Mode selector
18. Shaft lock
19. Carbon brush cap
20. Electronic speed controller.
21. Guide rail.
22. Protection guard.
23. Cutting angle scale.
Operating instructions
Placement and testing
Switching ON/OFF
- Press the switch lock (2) and then the ON/OFF switch
(1) to switch the plunge saw on.
- Release the ON/OFF switch (1) to switch the plunge
saw off.
Notes : Pressing the switch lock (2) unlocks the plunge
cut mechanism at the same time, so that the blade can
be moved downwards. The saw blade emerges from the
protective cover. When lifting the saw the motor slides
back into the initial position.
Tuning operations
Setting the cutting depth
The cutting depth can be set between 0 - 67 mm:
- Loosen the cutting depth limit stop knob (9) and slide it to
the desired cutting depth according to the graduated scale
(11) to set the cutting depth.
Note : The graduated values on the scale (11) apply for
straight cuts (90° cut).
The guide rail depth adjustment stopper (10) must be
tilted up when using the plunge saw without guide rail.
Only when using the plunge saw with guide rail, the guide
rail depth adjustment stopper is used to compensate for
the thickness of the guide rail.
(Fig 2)
Using the guide rail = guide rail depth adjustment stopper
down.