22
9 Preparing the Stud Welding Gun
©Walter Stauffenberg GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
Adjusting Lift
The adjustment piece for lift must not be turned by more than 360°.
1 - End ring
2 - Marking
3 - Adjustment piece lift
4 - Adjustment piece spring force
Place the stud welding gun perpendicularly onto the workpiece.
Pull the adjustment piece for lift (3) to the rear out of the locking position.
With the stud welding gun in contact with the workpiece, turn the adjustment
piece for lift in clockwise direction until the welding piston allows no further
movement in axial direction.
Now turn the end ring (1) of the stud welding gun until the „0“ position is aligned
with the marking (2) on the adjustment piece for lift.
Now turn the adjustment piece for lift in counter-clockwise direction to the
selected lift
(see table under point 9.2)
.
The lift can be adjusted in steps of 0.2 mm. (The empty space between 0 and
0.2 mm serves to mechanically balance out the lifting ring construction.)
Now push the adjustment piece for lift forward again into the locking position.
You can
reduce
the lift by turning the adjustment piece for lift
clockwise
.
You can
increase
the lift by turning the adjustment piece for lift
counter-clockwise.
Summary of Contents for SWG-WG
Page 1: ...Local Solutions For Individual Customers Worldwide Operating Manual SWG WG SWG WG...
Page 34: ......
Page 35: ......
