StarVedia IC602, User Manual, Page: 8 / 46

StarVedia Outdoor, Day&night IP Camera
8
2. Hardware description and quick installation/usage
The IP CAM is designed to be very easy to install and use. First, let’s see the
major components of the IP CAM products.
2.1. Major hardware components.
The major components of the IP CAM products are listed below :
1. Lens – the focus of the lens is fixed, you do not need to spend time to adjust the
focus, the effective focus range is from 30cm to infinity.
2. IR LEDs – there are totally 36 IR LEDs that can provide approximately 30m
distance night vision.
3. Light detector – this light detector can detect when the light is becoming dark and
turn on the IR LEDs automatically.
4. Power jack – this is the place to plug in the power adaptor. The power needed for
this IP CAM is 12V/1.0A, please make sure you are using the correct power
adaptor.
5. Ethernet jack – this is the place to plug in the RJ45 Ethernet cable.
6. Reset button – this is the button to reset the IP CAM to default factory settings.
You need to press the reset button for more than 4 seconds to enable the reset
function. Usually when you forgot the administrator account, you will probably
need to do this reset action to reset to the default factory settings. Please refer to
section 3.16 for more details.
7. Digital input terminal block – this is for alarm detection, an open circuit is off, a
close circuit is on.
8. Status indication LED (red) – this LED is to indicate the Internet connection status.
When the Internet connection is connected, the LED will be constant red light. If
there is any Internet connection problem, the LED will be blinking red light.
9. Ethernet indication LED (blue) – this LED is to indicate if the Ethernet link is ok
and packet traffic is sending/receiving. When the Ethernet cable is connected, the
LED is constant blue light. When there is packet sending/receiving, the LED is
blinking blue light.