Instruction manual
8
Complete an asynchronous copy
When you complete an asynchronous copy, the USB flash drives are copied or
compared independently, one at a time. When the green LED indicator next to a USB
flash drive stops blinking, you can remove the USB flash drive even if the other USB
flash drives are not done being copied or compared.
Note:
If the data size of the source USB flash drive is larger than the system’s buffer
memory, the system will automatically copy in synchronous mode.
Caution!
To avoid any copying errors, the source USB flash drive should be larger than
or the same size as the destination USB flash drive.
1. Use the Power switch to turn on the duplicator and eraser.
2. If necessary, change any of the copying settings (for example, copy area, copy
speed, target tolerance, and so on).
3. Insert the source USB flash drive into the Source USB flash drive port.
4. Insert up to 15 destination USB flash drives into the Destination USB flash drive
ports.
5. Highlight
Copy
and press the OK button.
6. If a confirmation message appears, press the OK button.
7. When the green LED indicator stops blinking, you can remove the destination USB
flash drive and insert another USB flash drive and the process will continue.
8. To check the copy status and progress for each of the USB flash drives, use the UP
and DOWN buttons to move through the USB flash drive ports.
Warning!
If the green LED indicator is blinking, do not remove the USB flash drive. If
you do so, you will interrupt the copying process and you could experience lost or
corrupted data as a result.
Interrupt the copying process
1. To stop the copying process while it’s in progress, do one of the following:
• To stop copying data to the slowest USB flash drive port, press and hold the UP
and DOWN buttons for 5 seconds.
• To stop copying data to all of the USB flash drive ports, press and hold the ESC
button for 5 seconds.
