Start italiana MAGLINK 16T, Installation Manual

Page: 22 / 48

Maglink 16T rev.08 2015-07 - ENG
22
ALARM DEFINITION
In the alarm definition section it is possible to set various alarm trip point for each level probe.
Alarm HH
very high alarm point in mm/inc.
Alarm H
high alarm point in mm/inc.
Alarm L
low alarm point in mm/inc
Alarm LL
very low alarm point in mm/inc.
Alarm Water
presence of water alarm point in mm/inc.
DELIVERY PARAMETER
Minimum delivery detection value for rate lt/min and gallons/inches.
LEAKAGE PARAMETER
Minimum Value in liters for the leakage detection.
TANK LEVEL
In the Tank level section it is shown the current tank status referred to the selected channel.
Product (mm/inc)
Product measure as detected by the probe of the selected channel.
Water (mm/inc)
Water measure as detected by the probe of the selected channel.
Temperature (C°)
Product temperature as detected by the probe of the selected channel.
RELAY DEFINITION
In this section it is possible to select the activation function of relay from 1 to 32.
The relay can be managed one by one for each channel or groups, one relay for
multiple channel.
First 16 relay are mounted into the main board, additional from 17° to 32° relay are
located in the expansion slave relay card connected to connector CN6 referred to the
bus of the probe on the main board of the console and having address 0.
Do not connect the expansion card after BRA-SIP card.