Maglink 16T rev.08 2015-07 - ENG
19
PCB SLAVE RELAY
This board connected to the probes bus with 0 address corresponds to relay configuration from 17 to 32.
R25 R26 R27 R28 R29 R30 R31 R32
R17
R18 R19 R20 R21 R22 R23 R24
Probes BUS Connection must be done before the barriers, if present.
Connections are made using two connectors on the top side of the board following these colors:
RED
:
+12V
BROWN :
RS485-B
BLUE
:
RS485-A
WHITE :
GND – 0V
S2
CONNECTIONS:
Each connector is composed
as follow:
Terminal strip 1
Terminal strip 2
Terminal strip 3
CONNECTOR n = RELAY N
Terminal strip 1:
COMMON
Terminal strip 2:
Normally open
Terminal strip 3:
Normally closed
RED
BROWN
BLUE
WHITE
Summary of Contents for MAGLINK 16T
