S8010
122
ENGLISH
PROCEDURE TO INSTALL A DRILL, HOLE SAW AND BIT:
1.
LOCK the Trigger Switch of the Drill / Driver, putting the button of the
Direction of Rotation Selector (NORMAL / LOCK / REVERSE) the center position
(LOCK);
2.
RELEASE or GRIP the Chuck to a point where the opening is slightly
larger than the diameter of the drill bit or hole saw support or bit that intend
to use;
3.
INSERT the drill bit ou the support of hole saw or the bit;
4.
TIGHTEN with the hand with safety the Chuck (fi gure 11A).
WARNING
: TURN the chuck body towards TIGHTENING (close the chuck).
DO NOT USE any kind of key to tighten or release the Chuck.
17 19 21 23
FIG.11
TORQUE
ADJUSTMENT
RING
DECREASE THE
TORQUE
INCREASE THE
TORQUE
WARNING:
CERTIFY that the drill bit is centered and that was
NOT introduced at an angle (fi gure 11B) on the
Chuck. This may cause the drill to be ejected from
the Chuck, resulting in serio us injury or possible
damage to the machine.
FIG 11A
Summary of Contents for S8010
