Part Number: 4530
Page 4
Version 1.5
© 2015 Starkey Products, Inc.
3.
Using the supplied
red wire tap, slide the Brown wire with Yellow stripe onto the tap. If you have
an XLT Sport grille and you are connecting the wiring to the driver side parking light, the wire
color is Green with Orange stripe. The wire should sit in the middle of the two teeth. Squeeze
down on the wire tap making sure it snaps closed. Do not cut wire! See picture 16.
Flip the L-Brackets for installation on
XLT Sport grilles.
Use the 2 of the large push-pins to
secure the L-brackets.
Locate the amber running light
connector behind the head light.
4.
Now skip to step 9.
5.
LED Headlamps =
Turn your steering wheel all the way to the left.
6.
Pull back the wheel well liner on the passenger side to gain access to the headlamp connector. It is
held on by 3 – 5.5mm screws.
7.
Locate the rectangular connector plugged into the back of your LED headlamp. It has 7 wires
coming out of it. Unplug the connector.
8.
Using the supplied
red wire tap, slide the Blue wire with Gray stripe (Pin#3) onto the tap. See
picture 16 below. The wire should sit in the middle of the two teeth. Squeeze down on the wire tap
making sure it snaps closed. Do not cut wire!
9.
Plug the red wire from the Light Bar wiring into the back of the wire tap. See picture 17.
10.
Use an 8mm socket or wrench to attach the
black
ground wire to the bolt shown in picture 18
below. Re-attach the bolt so the ring terminal makes proper contact and the bolt is tight.
Slide wire into place and close wire
tap completely.
Plug correct wire into the wire tap as
indicated above.
Attach the ground wire to the bolt in
front of washer fluid reservoir.
