Part Number: 4530
Page 1
Version 1.5
© 2015 Starkey Products, Inc.
2015-2017 Ford F-150 Raptor-Style Grille Lights
Parts List:
Quantity:
Tool List:
Bracket & pre-installed lamps
1
Flat head screwdriver
PB-4530 Parts Bag
1
Phillips screwdriver
Ratchet & Socket set
Pliers
Thank you for purchasing one of our products. Please familiarize yourself with the parts included as well
as the instructions before attempting installation. Please seek the help of a certified technician if you feel
unable to complete the installation safely and properly. Failure to read and follow the instructions below
may result in personal injury or damage to property. Starkey Products, Inc. and our retailers assume no
liability for failures to comply with guidelines and warnings outlined in this instruction manual.
For additional tips and tricks, visit our website to watch the installation video for this product!
Removing the grille:
Before beginning the steps below, turn off the vehicle, remove key, and engage the emergency brake.
1.
Open hood of truck and make sure hood is held open securely.
2.
Remove the black plastic radiator cover (shown in picture 1). The panel is attached by 11 plastic
pins. The pins are removed by prying up on center part and then prying up on the body of the pin.
See picture 2. Save pins and black panel for re-installation later.
3.
Remove the 2 bolts (7mm) that attach the headlight trim panels to the wheel well on each side of
the truck. Set aside for re-install later. See picture 3.
4.
Some models have factory fender flares. The fender flares are held on by clips. You can loosen the
fender flare enough (for headlight trim panel removal) without completely removing it. Simply
pull outward (towards you) on the front part of the fender flare until the first 2 clips unsnap.
5.
Remove headlight trim panels on each side of the truck. Start on the inside at the top and work
your way down and toward the outer corner of the headlight. There are clips holding the panel in
place. You will hear ‘popping’ sounds as the clips disengage. This is normal. If you encounter a
lot of resistance, check to make sure wheel well hardware has been removed as well as the outer
push pins removed in step 2 above. See picture 4.
6.
Remove the 4 bolts (10mm) located below the radiator cover we removed in step 2. These bolts
hold on the grille and active shutter system. See arrows in picture 5 below.
Remove black panel shown. Save 11
retaining pins for re-install later.
Pry up on center part of pin first. Then
pry out entire retainer pin.
Remove 2 - 7mm bolts on driver and
passenger side wheel well.
