from sliding, you are highly recommended to wear the anti-skid shoes; do not leave long hair.
11.
Wear the protective goggles; when cutting operation produces plenty of dust, the dust mask must
be worn properly; the glasses used for the daily purpose are only the impact-resistant lens, instead
of the safe glass lens.
12.
Clamp the work piece tightly. If necessary, use the clamper or the pincer pliers to hold the work
piece tightly; such practice is safer than the practice to hold with hands.
13.
Do not reach over the turning tool in any time; stand firm when working.
14.
Maintain the electric tool with care; keep the cutter sharp always and lubricate or replace the
appropriate fitting according to the operation manual.
15.
Do not unplug the power cord when making maintenance or other operation, such as change
accessory, saw blade, drill or cutter.
16.
Do not insert the power cord to start the electric tool without making confirmation; check to see if
the switch of the electric tool is closed before switching on the mains supply.
17.
Use the accessories according to the given requirements; read the operation manual in detail and
correctly use the accessories; it is very possible to cause personal accidental injury if using the
accessory wrongly.
18.
Do not touch the cutter in any time; the cutter is very sharp, so it may cause injury to you if you
touch it carelessly.
19.
Check to see if any part is damaged. If any part is damaged or worn, please replace it
immediately; if not, your working efficiency will be greatly reduced or even accident may
happen.
20.
Feed the material correctly; the work piece should be fed in a direction opposite to the cutting pan
or cutting blade instead of feeding in the direction as same as the turning direction to avoid
accidents.
21.
Keep your eyes watching the electric tools always; before you leave, you must be assured to
switch off the mains supply and that the electric tool stops completely.
22.
Use the designated replacement part only when using the electric tool.
23.
Use the prescribed part when repairing or replacing part.
Voltage:
When inserting the power socket, you must ensure to confirm if its voltage is in accordance with the
rated voltage of the electric tool. If the power voltage to be used exceeds the rated voltage of the
electric tool, it may not only damage your electric tool, but also cause personal injury to you or other
person. If the voltage of the power socket fluctuates frequently, you are not recommended to try it.
However, if the power voltage to be used is lower than the rated voltage of the electric tool, it may
also cause damage to the motor of the electric tool.
Supplementary Regulations on Safety of Aluminum Cutting Machine
1.
Wear the protective goggles.
2.
Do not operate the electric tool if there is no site protection in place.
3.
Do not use the electric tool in the context of flammable gases.
4.
Check carefully to see if the saw blade is broken or damaged or not before using the electric tool;
if yes, you must replace the broken or damaged saw blade to avoid accident.
5.
Use the special flange plate designed especially for the electric tool.
6.
Do not damage the saw blade shaft, flange plate (especially its mounting surface) or bolt of the
electric tool; check to see if the saw blade is in good condition.
7.
Confirm if the turntable is so solidly fixed solidly that it won't move in the operation process.
8.
You are highly recommended to remove debris from the workbench and keep the workbench
clean from time to time.
9.
Avoid the nails (before using the electric tool, you are highly recommended to check if there is
