cutting according to the parameters of the controller adjust the distance
between the nozzle and the steel plate, make the arc voltage is always
closer to set the voltage. This parameter can be directly as a set of highly.
Specific set number according to the selected power supply manufacturers
provide technical parameter settings.
2. Start arc latency, punch time should be used according to the actual
perforated time settings, different thickness of steel plate and different
current when the time is also different. Clockwise to lengthen the period of
rev arc, counterclockwise to reduce arcing time.
3. Positioning delay, initial positioning time is the initial positioning, cut down
to touch with steel plate, after ascending to the time required for setting
height. The time required for different lifting mechanism to promote a
certain distance is different too.It should be set according to the actual
situation. Clockwise rotation for higher position height, counterclockwise to
reduce positioning height.
4. The speed parameters, the parameters for debugging, available to open
less than 3mm of a word or a cross screwdriver adjustment, to reduce the
clockwise and counterclockwise to increase. Adjust the parameters affect
the motor rotation speed and the response time of the whole. The knob
position as shown in figure 4-1.
5. Set position limit switch logic, S1 jumper cap inserted between 1 and 2 for
the low effective, suitable for use normally closed proximity switch. Inserted
between 2 and 3 for the high effective suitable for open still proximity switch.
The factory default for the low effective. Jumper on the panel position as
shown in figure 4-2.
6. With or without positioning function setting, S2 jumper cap inserted in
between 1 and 2 for positioning function. Inserted between 2 and 3 for no
positioning function. Jumper on the panel position as shown in figure 4-2.
Figure 4-1
The speed and
sensitivity
