SF-HC25C3 Height Controller
10
24VG
COM
the public end of the
limit
switch ,Positioning
Of the limit switch is recommended to use normally open type.
The initial position switches is recommended to use type NPN normally
open.(see appendix wiring methods, 23 pages)
Initial position switches can also use the protective cap + relay mode.
figure 3-2-4 POWER SUPPLY
label
attribute
explain
note
24VG
input
Switch power supply output
negative side
By the switch
power supply
provide
24V+
input
The anode switch power supply
output
Requirements: switching power supply capacity is greater than 3.5 A above.
Note: when using starF CNC system, this table all wiring is direct numerical control
input/output interface, don't need to relay equipment transformation.It is best to use
shielded cable.
文件使用
"pdfFactory Pro"
试用版本创建