PROPANE LP CONVERSION INSTALLATION INSTRUCTIONS
- 7 -
COPYRIGHT ©
2020
, STARFIRE DIRECT, ALL RIGHTS RESERVED.
4.
The flex lines attached to the Gas Key Valve have been pre-tightened. Using two
adjustable wrenches, make sure they are nice and tight and did not loosen during
shipping.
5.
Both of the flexible gas lines will have a FLR x FIP fitting hand tightened at the end.
Attach the Flex line with the yellow tape to the
propane air mixer on bottom of
burner pan.
Attach the other line to your gas supply.
REMEMBER: Use “Pipe Joint Compound” or “Yellow Gas Tape” on all NPT fittings.
NEVER USE ON COMPRESSION THREADS!
8.
Using two ad
j
ustable wrenches, tighten the end of the first flexible gas line to the
compression fitting
on your
gas stub.
9.
Using two ad
j
ustable wrenches, tighten the end
of the second flexible gas line
(with yellow tape)
to the compression
fitting on the bottom side of the
Burner
System
.
M
a
k
e sure all fittings are tight and secure, then set
the
Burner System
into the
Fire Pit
.
10.
Test your connections for leaks before
first use.
Use a soapy water solution.
11.
Before placing lava rock in burner pan, light your burner to ensure proper
ignition. For lighting instructions, see page 8.