37
5.5.18
Firmware Upgrade
You can upgrade the Lynx L-320’s firmware, clicking on Update Gateway
under the Tools page. To upgrade the firmware, click browse, find the
firmware file to download. Make sure this is the correct file. Click on upgrade
firmware. Once the upgrade is complete the Lynx L-320 will reboot. You will
need to log back onto the Lynx L-320 after the firmware upgrade is
completed. The firmware upgrade should take about 5 minutes to complete.
Note: Do not remove power from the Lynx L-320 during the firmware
upgrade procedure.
Figure 1-31: Firmware Upgrade
5.5.19
Restore to Default
The restore to factory defaults feature will set the Lynx L-320 to its factory
default configuration by resetting the Lynx L-320. You may need to place
the Lynx L-320 into its factory defaults if the configuration is changed, you
loose the ability to interface to the Lynx L-320 via the web interface, or
following a software upgrade,. To reset the Lynx L-320, simply press the
reset button for about ~ 10 seconds. The Lynx L-320 will be reset to its
factory defaults and after about 30 ~ 40 seconds the Lynx L-320 will become
operational again.
A prompt as the one shown in Fig 1-31 will pop-up.
