7
3. Installation instructions and requirements
Pool heating must be installed by a skilled team. Users must not install it independently because it could
cause injury, or damage to the equipment.
A. Installation
1) Pool heating must be installed in a place with good ventilation;
2) The frame must be prepared with screws (M10) into the concrete base or brackets. The concrete base
must be strong and anchored. The bracket must be strong with an anticorrosive treatment.
3) Do not block the in
fl
ow or out
fl
ow area with articles which would obstruct the
fl
ow of air. There must
not be any obstruction within 50cm behind the main equipment; otherwise, heating performance will be
decreased or absent.
4) The equipment requires a pump attachment (supplied by the customer). Recommended pump speci
fi
ca-
tion:
fl
ow: see technical parameters, max. transport height
≥
10 m;
5) Once the equipment is operating, condensate will leak from the lower part. Give attention to this oc-
currence. Insert nozzle (accessory) into the opening and secure well. Then attach the condensate drainage
tube.
B Electrical connection
1) Connect equipment to corresponding mains. The voltage must correspond with the product’s speci
fi
ed
voltage.
2) Earth the equipment correctly
3) Electrical connection must be carried out by a professional technician and according to the connection
diagram.
4) Install protection against leakage current according to local regulations (leakage current
≤
30 mA).
5) The mains supply and signal cable must be arranged systematically and logically, so that cables do not
interfere with each other.
C. After completing all connections and repeated inspection, switch the equipment on.
VI. Operating instructions
Picture of the button arrangement
Setting up water
temperature and time
Timer inspection
Timer switched on On
On / Off
Clock
Ti
m
er
switched-of
f
Ti
m
er
pilot light
Heating/cooling
indicator
EN
