– 16 –
10) Do not change the paper width during use. The thermal printing head, rubber roller, and
cutter wear differently according to the paper width. This can cause the printing or cutter
movement to malfunction.
11) Do not transport the printer with its cover open and holding it by the cover.
12) Do not forcibly pull on the interface cable, power cable, or cash drawer cable that is con-
nected. To detach a connector, make sure to grasp it at the connector portion, without ap-
plying excessive stress on the connector at the printer.
Notes on Using the Auto Cutter
1) To print after a cut, feed 1 mm (8-dot line) or more of paper.
2) If the cutter is not in its home position after an error, first eliminate the cause of the error;
then, turn the power back ON.
3) If the printer is placed horizontally, the use of the partial cut is recommended. If you use
the full cut, the cut pieces of paper may fall into the paper outlet passage, causing a paper
jam as a result of cutting multiple pieces of paper. Therefore, do not use the full cut if the
printer is placed horizontally.
4) If you use the full cut, make sure to remove the piece of paper after each cut.
5) Do not attempt to remove the paper during a cut, as this can cause a paper jam.
