64
Slip Printer Control
<ESC>
<SI>
n
(1B)H
(0F)H
n
Setting slip sensor
Sets the slip printer TOF/BOF sensor according to the value of n.
TOF Sensor
BOF Sensor
n = 00, “0” :
Valid
Valid
01, “1” :
Valid
Invalid
02, “2” :
Invalid
Valid
03, “3” :
Invalid
Invalid
The default value of n is 0.
This command is only valid with the slip printer.
<ESC>
<FF>
n
(1B)H
(0C)H
n
Slip function
After printing the data in the line buffer, operates the slip printer
according to the value of n.
n = 00, “0” :
Operates the clamp
01, “1” :
Releases the paper
02, “2” :
Releases the paper and waits until it is removed
03, “3” :
Feeds the paper backward (backfeed) until it
moves past the TOF sensor, then releases the
paper. (See NOTE below.)
04, “4” :
Feeds the paper into the printer (operational feed)
until it moves past the BOF sensor, then releases
the paper.
05, “5” :
Feeds the paper according to the direction and
length set by <ESC> <VT> m n (the paper is not
released)
(NOTE) When the slip paper is attached to duplicates, a paper jam
may occur if the paper is always fed backward. Therefore,
the paper should not be ejected with n=3. To feed slip paper
attached to duplicates backward, use <ESC> <VT> to set
the eject length to about half of the paper length, then eject
the paper using <ESC> <FF> 5.
This command is only valid with the slip printer.
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
Summary of Contents for Star SCP700 Series
