- 14 -
3.3 Memory Switch Setting
(By the buttons on the printer.)
For details on the printer settings,
refer to [ Setting Table] on page 17.
The setting change by memory switch is enable before shipment.
The setting change by memory switch is the following steps.
1. Turn on the printer power by pressing and holding down the FEED button and the POWER button
simultaneously for 5 seconds or more. The printer will perform self printing.
2. The printer prints out the contents up to the QR code in case of the ESC/POS mode or the contents
* When the above steps 1 to 4 are performed while the setting change by memory switch is disabled, the
printer prints out "Memory SW setting = Enabled" and the setting change by memory switch is disabled.
up to the memory switch setting information in case of the StarLine mode. Then, release the POWER
button and the FEED button, and press the POWER and FEED buttons simultaneously within 2 seconds.
Hold down both buttons for 2 seconds or more and release the buttons.
3. If the printer prints out “Memory SW setting = Disabled”, the setting change by memory switch is
enabled.
FEED
POWER
ERROR
FEED
POWER
ERROR
Release the FEED button
and the MODE button.
Then, press the FEED and MODE
buttons simultaneously.
Within
2 seconds
Self test finishes
FEED
POWER
ERROR
3 seconds
Start self test
Emulation : ESC/POS
Communication Port : Bluetooth(iAP)