D-F0382 NP-266/366 Product specifications Ver.1.10
17
4.2 Processing error
1) Error detection details
Name Status
Status
ALM
status
Removal
Comm. error
Paper near
empty
Rear cover
open
Paper end
Excessive
Head temp
Cutter error
Presenter
error
Presenter
cramp
232C Comm. error
Parity
Overrun
Flaming
Data “?” print
Remaining paper detect
near empty detection
Rear cover open
No paper
Over approx.80
°
C
Cutter error
Presenter error
Presenter cramp the paper
－
0 bit 1
1 bit 1
2 bit 1
3 bit 1
4 bit 1
5 bit 1
6 bit 1
－
Blink-1
On
On
Blink-2
Blink-2
Blink-3
Blink-3
Adjust comm.condition
Load paper
Close the rear cover
Load paper
Return regular operation
At 60
°
C(approx.)
After removing the error,
(Jam etc), turn on power
again or input /RESET
signal
After removing the error
(jam etc), turn on power
again or input /RESET
signal
Remove the paper
When the above errors are detected (except transmission error and paper empty end error), printer
stops all operation and turn on the error bit of the status
.
Note: Blink-1: 0.5 sec on and 0.5 sec off
Blink-2: 2.5 sec on and 0.5 sec off
Blink-3: 0.2sec on and 0.2sec off x 3 times, 1.0 sec on, 0.2 sec off
2) Return to normal status from error statuses
Remove causes of error statuses and turn the power on again or input the /RESET signal
to return to normal. When this process is activated, at the time of power switch turned off,
the printer will be initialized, so that settings are required again.
If data remains in the buffer, attention should be paid
