Star Micronics LC24-15II, User Manual

Page: 39 / 155

32
Top of form
When you power on the printer, the top-of-form position is automatically set
to the current position. If this is not where you want the top of the page to be,
you can change the top-of-form position as follows:
1. Press the ON LINE button to set the printer off-line.
2. Press and hold down the ON LINE button.
3. While holding the ON LINE button down, press the PITCH button,
then release both buttons at the same time. The printer will beep to indicate
that the top-of-form position has been set.
Forward micro-feed
For fine alignment, you can feed the paper forward in very small increments
as follows:
1. Press the ON LINE button to set the printer off-line.
2. Press the ON LINE button again and hold it down.
3. While holding the ON LINE button down, press the PAPER FEED
button. The paper will start advancing in a series of small steps.
When you want to stop, release both buttons.
Reverse micro-feed
You can also feed the paper in small increments in reverse, to return to a
higher position on the same page.
1. Press the ON LINE button to set the printer off-line.
2. Press the ON LINE button again and hold it down.
3. While holding the ON LINE button down, press the SET/EJECT button.
The paper will start moving backwards in a series of small steps.
When you want to stop, release both buttons.
Changing the auto loading position
Normally, the printer automatically loads the paper one line from the top
edge. If you want to change this value, follow this procedure:
1. Load the paper by pressing the SET/EJECT button.
2. Change the print position using the micro feed function.
3. After you set up the desired position, press the ON/LINE button to save
the value.