28
Chapter 3: Using the EDS Mode
The letters “EDS” stand for “Electronic DIP Switches.” Just like the small DIP
switches that are used by many computers, printers, and other devices, the EDS
mode lets you configure the printer so that it matches your system and software
needs. This chapter describes how to enter the printer’s EDS Mode and provides
details about available settings and how to change them.
All switch settings, except for F-2, are ON when the printer is shipped from the
factory.
About EDS Mode settings
EDS Mode settings are grouped among six “banks” (representing banks of
switches) that are identified by the letters A through F. Each bank contains a
number of “switches” numbered 1 through 6 that you can turn on and off to
configure the printer.
Entering the EDS Mode
❏
Make sure that paper is loaded in the printer.
❏
Turn off the printer.
❏
While holding down the control panel’s
ON LINE
,
LINE FEED
, and
FORM FEED
buttons, turn the printer back on.
This causes the following message to be printed, which indicates the printer
is in the EDS Mode.
Summary of Contents for LC-1021
Page 1: ...USER S MANUAL LC 1021 HA10H 80825080 DOT MATRIX PRINTER ...
Page 90: ......
