Star Micronics DP8340 Series, User Manual

Page: 33 / 59

– 29 –
7-5. Peripheral Unit Drive Circuit
The Control Board of this printer is equipped with a circuit for driving peripheral
units (Paper Cutter, Take-Up Device, Cash Drawer, etc.)
The 6P Modular Jack is used as the Drive Circuit. When using this circuit,
connect the peripheral unit cable to the 6P Modular Jack (cable is not included).
Note: Peripheral unit drive circuit connector only connects to peripheral units
such as cash drawers, etc.
Do not connect it to a telephone.
1. Drive Circuit
Drive
12V,MAX. 1A
Output
Absolute Ratings (Ta = 25˚C)
D
1
Voltage Breakdown 100V
D
2
Peak Forward Current 1A
Note: It is impossible to drive pe-
ripheral devices 1 and 2 at
the same time
[Printer side]
Note: Make sure that the metal structural parts of the peripheral device are
connected to frame Ground (Pin 1) to provide a static drain path.
2. Control code
Codes for Drive Circuit control are ESC BEL n
1
n
2
, BEL, FS and SUB.
Refer to the Control Codes in Section 5.
7-6. Emergency Suspension
If an error condition is detected during operation, the printer will stop printing and
ERROR signal will go Low.
It is necessary to turn the printer power off and on again in order to recover from
the emergency suspension.
This printer can detect the following error conditions:
a. Motor Lock
b. Defective timing detector
Figure 7-5. Drive Circuit
Figure 7-6. 6P Modular Jack
Connector
Figure 7-7. Recommend Cable