- 6 -
REV-7.23.2012, CSA
you see the RED LED flash, please take care and check every facet of your electrical
system.
Mode 2 - Auto Mode
The Auto mode is triggered by an “
ON-OFF-ON
” switching of the
off-on light switch
located inside the RV. However, if the fixture is already powered up in Manual Mode,
then switching the
fixture “
OFF then ON
” will trigger the Auto
Mode function. In the
Auto Mode, the daylight sensor, Star Monitor
™
, and motion sensors are operable. Once
the Smart Light 1000
™
detects motion it will activate the bulb and stay on for one
(1) minute. If the fixture again detects motion before the (1) minute is up, then the
timer will reset, and the count-down will recommence. If no other motion is
detected, then the light will deactivate, and the area around your coach will continue
to be monitored.
Finally, don’t be alarmed if the
Smart Light 1000
™
does not detect
your motion at the exact same point each time. A variety of factors dictate when and at
which point the motion detection units will activate the light bulb. If you have questions
about this nuance, please contact our engineering help desk for a more thorough
explanation.
Starlight’s’
exclusive Star Monitor
™
continues to
monitor the RV’s Battery Voltage
Level. If the voltage drops to the predetermined level, a RED LED will blink behind the
lens as a warning of a low battery condition. Star Monitor
™
will, in the auto mode, turn
the Smart Light 1000
™
fixture off. When the battery rises past the predetermined level,
the Smart Light 1000
™
fixture will reset itself automatically and continue operation.
Side note: Customers have asked why we deactivate the Smart Light 1000
™
at 11.5
volts. The reason is that at this voltage level, most of your major appliances will cease to
operate (such as your refrigerator). Also, at 11.5 volts, your batteries are working at less
than 35% capacity.
The Smart Light 1000
™
has three (3) operating phases as listed below:
1.
When activated in the
“
DAY-TIME Auto Mode
”
function, the Multi-
Colored LED will blink
“
BLUE
”
. This indicates that the fixture is
activated, it is daytime, your battery is charged, and that the unit will not
illuminate if it senses motion.
2.
When activated in the
“
NIGHT-TIME Auto Mode
”
function, the Multi-
Colored LED will blink
“
GREEN
”
. This indicates that the unit is
activated, it is dark outside, your battery is charged, and that the light will
illuminate if the proper motion is detected.
3.
When the Smart Light 1000
™
fixture is in either mode and the Star
Monitor
™
function has been activated by a low battery condition, the
Multi-Colored LED will blink
“RED”
. Regardless of the time of day, the
light will not illuminate with any motion until the low battery condition is
remedied.
